|
Join The Student Room TodayBe part of the UK's largest and fastest growing student community. It's free to join and a lot of fun - Get inspired, express your ideas, interact and share Revision:Equilibrium - 08From The Student RoomTSR Wiki > Study Help > Subjects and Revision > Revision Notes > Chemistry > Equilibrium - 08 8.1 Dynamic equilibrium8.1.1In all reactions, there are in fact two reactions occurring, one where the reactants produce the products, and the other where the products react to form the reactants. In some reactions, this second reaction is insignificant, but in others there comes a point where the two reactions exactly cancel each other out. Thus the reactants and products remain in equal proportions, though both are continually being used up and produced at the same time.
8.2 The position of equilibrium8.2.1The equilibrium constant Kc is a constant which represents how far the reaction will proceed at a given temperature.
8.2.2When Kc is greater than 1, products exceed reactants (at equilibrium). When much greater than 1, the reaction goes almost to completion. When Kc is less than 1, reactants exceed products. When much less than 1 (Kc can never be negative...so when it is close to zero) the reaction hardly occurs at all.
8.2.3The only thing which can change the value of Kc for a given reaction is a change in temperature. The position of equilibrium, however, can change without a change in the value of Kc.
8.2.4Yeah...well...based on the previous section, you should be able to product what's going to happen given a reaction if the temp, pressure of concentration is changed.
8.2.5A catalyst does not effect either Kc or the position of equilibrium, it only effects the rate of reaction.
8.2.6
as can be seen, there are more mols of gas on the left than the right, so a greater yield will be produced at high pressure. The reaction is exothermic, therefore it will give a greater yield at low temperatures, however this is not possible as the rate of reaction becomes too low, and the temperature must actually be increased. A catalyst of finely divided iron is also used to help speed the reaction (finely divided to maximize the surface area).
Comments |
|