Turn on thread page Beta
    • Thread Starter

    I'm just trying to learn a little bit about CAD myself (I'm not studying engineering at uni level). Therefore this is a fairly basic question.

    If drawing up a plan view (bottom of the attached image) with a corresponding side view directly, precisely how would you go about putting in the vertical lines connecting the two so that these are in precisely the correct place.

    Do you simply draw the horizontal line at the top (longer than required), then switch on the required OSNAPS?

    Which OSNAPS would you have switched on?

    Thanks for any help.

    Name:  drawing19.jpg
Views: 32
Size:  59.2 KB
Submit reply
Turn on thread page Beta
Updated: October 23, 2017

University open days

  1. University of Cambridge
    Christ's College Undergraduate
    Wed, 26 Sep '18
  2. Norwich University of the Arts
    Undergraduate Open Days Undergraduate
    Fri, 28 Sep '18
  3. Edge Hill University
    Faculty of Health and Social Care Undergraduate
    Sat, 29 Sep '18
Which accompaniment is best?

The Student Room, Get Revising and Marked by Teachers are trading names of The Student Room Group Ltd.

Register Number: 04666380 (England and Wales), VAT No. 806 8067 22 Registered Office: International House, Queens Road, Brighton, BN1 3XE

Write a reply...
Reputation gems: You get these gems as you gain rep from other members for making good contributions and giving helpful advice.