Turn on thread page Beta
    • Thread Starter
    Offline

    1
    ReputationRep:
    Hello guys & gals
    I am just learning about tap & Die never done it before and would like to ask some questions before i start ,But for me its very confusing even after looking at charts online i still am not sure which size drill bit i would need so i can make M18X2.5 thread .

    And what size bar would i need in order to make a thread on that to fit the hole with new thread on from the M18X2.5 ..


    Thank you ..

    Karl
 
 
 

University open days

  1. University of Bradford
    University-wide Postgraduate
    Wed, 25 Jul '18
  2. University of Buckingham
    Psychology Taster Tutorial Undergraduate
    Wed, 25 Jul '18
  3. Bournemouth University
    Clearing Campus Visit Undergraduate
    Wed, 1 Aug '18
Poll
How are you feeling in the run-up to Results Day 2018?

The Student Room, Get Revising and Marked by Teachers are trading names of The Student Room Group Ltd.

Register Number: 04666380 (England and Wales), VAT No. 806 8067 22 Registered Office: International House, Queens Road, Brighton, BN1 3XE

Write a reply...
Reply
Hide
Reputation gems: You get these gems as you gain rep from other members for making good contributions and giving helpful advice.