Figure 5 below shows a typical go kart wheel and shaft assembly. From further inspection it was decided that the assembly could be made simpler and easier.
- a) Design and describe an improved and simpler assembly to hold the wheel on the shaft (sketch it up and annotate it).
- b) List all the tools you would use and for what purpose.
- c) State the most suitable finishing processes that could be used to protect the shaft. What considerations must you take into account? The shaft is made from mild steel.
Genuinely any help on any of the questions above will help because I need to submit this assignment tomorrow and I'm struggling to complete this task, I would appreciate anyone's help right now.
Turn on thread page Beta
I need help with this Engineering question watch
- Thread Starter
- 14-03-2018 21:35